[ ] Tuesday, 3 September 2019 [ ]

Bus Pirate v4.0

HiZ>i
Bus Pirate v4
Firmware v6.0-a3 
DEVID:0x1019 REVID:0x0004 (24FJ256GB106 UNK)
http://dangerousprototypes.com

Checking modes:

HiZ>m
1. HiZ
2. 1-WIRE
3. I2C
4. SPI
5. 2WIRE
6. 3WIRE
7. LCD
8. DIO
x. exit(without change)

(1)>no mode change
no UART! The pinout is different see Bus Pirate V4 pinout, so need to update firmware.

So grabbed my Bus Pirate 3: 

port:fred ~> cu -l /dev/cuaU1 -s 115200
Connected to /dev/cuaU1 (speed 115200)

HiZ>i
Bus Pirate v3a
Firmware v5.10 (r559)  Bootloader v4.4
DEVID:0x0447 REVID:0x3046 (24FJ64GA002 B8)
http://dangerousprototypes.com

mount point busy

When trying to umount a USB Pendrive I had the following message: umount: /mnt/sd: Device busy doing: 

port:fred /mnt> doas fstat /mnt/sd
USER     CMD          PID   FD MOUNT        INUM  MODE         R/W    SZ|DV NAME
fred     gvfsd-trash  3979   17 /mnt/sd         1  drwxr-xr-x     r    16384 /mnt/sd
fred     gvfsd-trash  3979   18 /mnt/sd         1  drwxr-xr-x     r    16384 /mnt/sd
revealled what the issue was.

Raspberry Pi Recovery

This topic is covered on the Downloads page, but trying it in my Raspberry Pi 3 Model B v1.2, however using the bootloaders did not seem to fix my pi. Ended up using the Raspbian Buster Lite image flashed to an SD card and used HDMI and USB keboard.

now need to try to reinstall OpenBSD.

rpibus pirate

$Id: dates.htm,v 1.1252 2019/09/18 07:52:47 fred Exp $

$Id: diary,v 1.27 2017/09/01 17:12:44 fred Exp $